You may have to rotate one of the Conclusion Use your foot to press down on the bottom end cap while pulling down on both poles so that they are parallel to one another and taut against both walls. Carefully spread out each section of pole to its full length and place them inside your tub or shower stall at an angle so that they rest against opposite walls.Ĥ. Remove any sharp edges with a file or sandpaper before reassembling.ģ. Note: If your ceiling height is less than 8-foot-6 inches, adjust the height of the pole by twisting off the upper section of the pole and cutting it to size with a hacksaw. Rotate the feet until they lock into place. Place the adjustable feet on a flat surface inside the tub or shower. Rotate the pole until it locks into place.Ģ. Place the expanding end of the shower pole into the base. If they do not, check that all springs are tightened properly and shelves are lined up correctly. Insert screws through these holes and tighten them in place using screwdriver. Line up the holes in the sides of your caddy with the holes on your tension pole. Slide the top spring over top of pole and tighten it into place with a screwdriver. Attach the bottom spring to the bottom of pole and tighten it into place with a screwdriverĪttach top spring. It should slide under the lip of the unit. Place the bottom of the caddy onto the floor of your shower. Unscrew the top of the tension pole and adjust so that it is level with the height marks on the side of the pole.Make sure the pole is completely straight before tightening it.Adjust the tension pole according to instructions.Measure from floor to ceiling to determine how high you will need to adjust the tension pole.This product adjusts to fit ceilings between 80 and 105 inches tall. Installing the Zenna Home Tension Pole Shower Caddy is a quick and easy way to organize your shower. This is a temporary solution until you get a grip cap or shower curtain tension rod. Twist and squeeze the ends together so that they stay attached. Attach one end of the wire to the bottom of the pole and then wrap it around both the pole and caddy (or use two wires, one going around each leg). Cut a piece of 20 gauge wire about 1 foot long (30 cm). If your caddy does not have a thumb screw, then you will need to wrap wire around the pole and caddy. Most tension poles have a thumb-screw cap at the bottom of the pole. Slowly extend the pole toward the ceiling until it is flush against your shower head and all four rubber pads are touching tile or wall surface. If you don’t want to drill into your tile or wall, you can use adhesive wall pads instead. Next, screw in the two tension screws on either side of pole. Once you’ve marked off this initial spot, use a pencil to mark off every 4 inches, up to the top of your shower head. Using a level or a tape measure, mark off where you’ll want the bottom of the caddy to be secured. The bottom of the caddy should be installed at least 4 feet from the floor. Make sure the caddy is aligned with all of the marks on the pole and starting at the designated level (in our case, 4 feet)įirst, measure the height of your shower head on the wall. To keep your tension rod caddy looking new, clean it with a non-abrasive cleaner once a week to remove soap scum and mildew buildup. Then, add your shower accessories to the caddy. Make sure that the caddy is secure on the pole and will not fall down. Do this until you can no longer turn it, but be careful not to break it. Tighten the bolt on the bottom of the caddy cup by turning it clockwise. Make sure that you have it aligned so that the pole fits snugly inside the caddy’s cup. Make sure the caddy is aligned with all of the marks on the pole and starting at the designated level (in our case, 4 feet).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |